Quooker PRO3-VAQ E Installation Guide download pdf (Page 10)

Connecting water

• NOTE: The VAQ E operates under mains water pressure and must always be

fitted with the supplied inlet combination and pressure reducing valve.

• The Nordic boiling-water tap or the Fusion tap must be installed according to

the locally applicable regulations.

• The inlet combination will release drips of expansion water while the water in

the tank is heating up in order to regulate the pressure inside the tank.

• Position the inlet combination as high as possible to create a sufficient height

distance between the inlet combination and the point where the waste hose

connects to the waste pipe. This is necessary to allow the expansion water to

flow away and to prevent water from backing up from the waste pipe (see the

figure at step D4).

1 Cutting through

cold water pipe

Close the main shut-off valve. Cut

through the cold water pipe at a

suitable point.

2 Fitting T-joint

Fit a T-joint (not supplied) between

the pipe sections.

3 Fitting pressure

reducing valve

Connect the pressure reducing valve

to the T-joint with a piece of copper

piping (Ø 15mm). NOTE: The pressure

reducing valve must be fitted in the

correct direction (see image).

4 Fitting the inlet

combination

Connect the inlet combination to the

pressure reducing valve. The inlet

combination can be fitted in any direc-

tion, but the grey funnel must always

be pointing straight downwards. Close

the stop valve on the inlet combina-

tion, open the main shut-off valve and

check for leaks.

3 4

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 16

No comments

Quooker PRO3-VAQ E Installation Guide Page 10