Quooker PRO3-VAQ E Installation Guide

Installation guide VAQ EBefore installing read this guide first

Connecting water• NOTE: The VAQ E operates under mains water pressure and must always befitted with the supplied inlet combination and pressure reduci

Connecting wasteThe Quooker tank releases expansion water via the inlet combination which isfed into the grey funnel. The funnel is connected to the w

Connecting tank with Nordic tap• The Quooker tank is supplied with a UK 3 pin plug and requires a standard 13 amp earthed socket. • If the mains lead

Connecting tank with Fusion tap• The Quooker tank is supplied with a UK 3 pin plug and requires a standard 13 amp earthed socket. • If the mains lead

Disconnecting tank• In case of service.• The Q-shaped button on top of the tank is the on/off switch.1 23 41 Switching offPress the on/off switch at t

Declaration of conformityQuooker B.V., Staalstraat 13, 2984 AJ Ridderkerk (The Netherlands) herewith declares, on our own responsibility, that the pro

UK | 30.225.03 | V08Q U O O K E R U K L T D 3 Waterpark Hall Montpellier Mews Salford M7 4ZY (UK) P +44 (0)207 9233355 F +44 (0)207 9001590

The operation of the Quooker VAQ EThe Quooker system consists of a small tank under the sink which is connectedto the Nordic boiling-water tap or the

Technical specificationsTank PRO3-VAQ E PRO7-VAQ EVoltage 230 V 230 VWattage* 1600 W 2900 WCapacity 3 litres 7 litresHeating-up time* 10 minutes 15

1234 51. PRO3 -VAQ E or PRO7-VAQ E tank2. Nordic boiling-water tap, small washers, centring ring, metal ring, brass sinknut and two screwsor Fusion ta

It is recommended that you install the Quooker in the following order:A. Drilling holeB1. Fitting Nordic tapC. Connecting waterD. Connecting wasteE1.

It is recommended that you install the Quooker in the following order:A. Drilling holeB2. Fitting Fusion tapC. Connecting waterD. Connecting wasteE2.

Drilling hole• NOTE: The tap hole for the Nordic boiling-water tap should be 32 mm indiameter. The Fusion tap hole should be 35 mm in diameter.• For d

1 Tap throughwork topPush the tap through the hole in thework top. NOTE: When fitting the tapin a 32 mm hole, the black plastic ringneeds to be remove

1 Tap throughwork topPush the tap through the hole in thework top.2 Securing tapPosition the brass fixing plate aroundthe hoses. Screw the fixing nut